180° Bin Tip Description
This 180° Bin Tip for 300 Litre tote bins is designed to lift and tip at a discharge height of 2200mm. The 180° Bin Tip is constructed from Grade 304 stainless steel and is fully TIG welded throughout. Lifting with the 180° Bin Tip is achieved by a ¾” Duplex chain driven by a motor gearbox mounted at the top of the main column. This 180° Bin Tip is designed to be mobile on castors.
Safety Guard to PD 5304 Safety of Machinery
The safety guard is constructed from 40 x 40 x 3mm stainless steel box section, 40 x 40 x 3mm wire stainless steel weld mesh and 2mm stainless steel sheet to meet the requirements of PD 5304 Safety of Machinery. It encloses the 180° Bin Tip to a height of 2200mm on three sides with a hinged door on the fourth side. The guard door is electrically and mechanically interlocked preventing the 180° Bin Tip from operating with the door open. In addition, the guard door can only be opened when the lifting carriage is at the full down position.
180° Bin Tip Electrical Control
This 180° Bin Tip is fitted with an IP65 Stainless Steel Control Panel which is mounted on the safety guard. The control panel incorporates the following controls; Up, Down, Guard Release, Emergency Stop and a Reset Facility. The 180° Bin Tip operation is latched via push buttons so that pressing the ‘Up’ push button will raise the lift to the full up position. Once the 180° Bin Tip has discharged the load, pressing the ‘Down’ push button will return the machine to the full down position. The control panel has the facility for a ‘call to run’ signal to be connected if required.