Double Pillar Pallet Tipper
BTM2P/1200/1210/B/G
Double Pillar Pallet Tipper Description
This double pillar Pallet Tipper is designed to lift and tip a 1200 Kgs Pallet Box at a discharge height of 1210mm. The double pillar Pallet Tipper lifting frame was constructed from Grade 304 stainless steel and the main body was from mild steel with a painted finish. The lifting is accomplished via chains driven by a motor gearbox mounted at the top of the one column with a crossover shaft to the other column. The double pillar Pallet Tipper is designed to be bolted to the floor.
Safety Guard to PD 5304:2005 Safety of Machinery
The safety guard is constructed from 40 x 40 x 3mm mild steel box section and 40mm aperture, 3mm mild steel weld mesh to meet the requirements of PD 5304:2005 Safety of Machinery. It encloses the double pillar Pallet Tipper to a height of 2200mm on two sides, 1000mm at the front with hinged door on the fourth side through which the Pallet Boxes are loaded. The guard door is electrically and mechanically interlocked preventing the double pillar Pallet Tipper from operating with the door open. In addition, the guard door can only be opened when the lifting carriage is at the full down position.
Double Pillar Box Tipper Specification
|
DESCRIPTION
|
DOUBLE PILLAR PALLET TIPPER
|
|
MODEL No.
|
BTM2P/1200/1210/B/G
|
|
CAPACITY
|
1200Kgs
|
|
TIPPING HEIGHT
|
1210mm
|
|
TIPPING ANGLE
|
135 DEGREES
|
|
OVERALL HEIGHT
|
TO BE CONFIRMED
|
|
MACHINE HANDING
|
LEFT OR RIGHT HAND AVAILABLE
|
|
TIPPING CHUTE
|
OPTIONAL
|
CONTAINER DESCRIPTION
|
PALLET BOX (1430 x 1430 x 1200mm) OR
DOLAF BOX (1200 x 1000 x 800mm)
|
|
BASE ARRANGEMENT
|
BOLTED TO THE FLOOR
|
|
CONTROL CIRCUIT
|
24Vac (STANDARD)
|
|
ELECTRICAL RATING
|
IP65
|
|
LIMIT SWITCHES
|
ADJUSTABLE ROD
|
|
MOTOR DETAIL
|
2.2 Kw, 3 PHASE, 50 CYCLE, 415V
|
|
MOTOR BRAKE
|
415V SEPARATELY EXCITED
|
|
GEARBOX DETAIL
|
SIEMENS
|
|
LOAD CHAIN
|
1" SIMPLEX SEDIS DELTA Z
|
|
TENSION CHAIN
|
¾” SIMPLEX DELTA Z
|
|
LIFT SPEED
|
6.4 METERS/MINUTE
|
Double Pillar Pallet Tipper Application Story
This double pillar Pallet Tippet was designed to lift and tip either a 1200 Kgs Pallet Box or a 600 Kgs Dolaf Box into a vibratory feed hopper at the start of a Packing Line. To allow both boxes to be tipped, there was a changeover frame that was loaded into the double pillar Pallet Tipper lift carriage prior to loading the smaller Dolaf Boxes. The rate of flow of the products from the boxes was also controlled with a hinged flap arrangement that opened gradually as the boxes tipped further. The biscuits were then drawn away using the Vibratory Feeder at a variable rate to suit the Packing Line speed.
|